|
No Skidding Slip Resistant Acrylic Clear Aerosol Spray, Product No. 11935C is a clear acrylic resin blend that air dries rapidly and retains translucency, durability, flexibility and non yellowing characteristics. 11935C is formulated using a recycled plastic particle for enhanced anti slip properties. This product is designed for increasing traction on steps, ramps, boat decks, diving boards, snowboards, skateboards, surfboards and other sport surfaces where increased traction is needed. Ideal for coating concrete, wood, and acrylic surfaces.
Surface must be clean dry and free of grease and other contaminants. Clean with No Skidding FlexcleanTM or On GuardTM and sand surface if required. If cleaned with No Skidding FlexcleanTM or On GuardTM then after cleaning be sure to rinse thoroughly and be sure that the surface has dried completely before applying coating. Surface should be slightly abraded before application using 000 steel wool or other fine particle size media. As product wears further applications may be necessary. Coating should be steel wool abraded between coats.
No Skidding Slip Resistant Acrylic Spray is designed for aerosol spray application. Clean overspray with acetone.
Always test small area before application. Read application instructions on label.
Concrete, acrylic, wood, fiberglass.
This product contains solvents and/or other chemical ingredients. Adequate health and safety precautions should be observed during all storage, handling, use and drying periods.
READ MATERIAL SAFETY DATA SHEET BEFORE USING THIS PRODUCT.
|
Type: Slip resistant texture acrylic coating. Spray, product no. 11935C
Vehicle: Acrylic
Volume solids: 11.7%
Weight solids: 15.25%
Weight per spray: 1 lb.
Viscosity: Thin liquid
Coverage: Up to 20 ft2 @ 1 mil
Recommended dry film: 1.0mil minimum
Gloss: Satin
Cleanup: Toluene, Xylene, or Lacquer thinner
% Paint per spray can: 45%
Color: Clear
Dry Time: 10-20 minutes at 77 degrees Fahrenheit
Full cure: 24 hrs. @ 77 degrees Fahrenheit
Packaging: 12 X 12 oz. net wt cans per case
The technical data and suggestions for use in this product data sheet are currently correct to the best of our knowledge, but are subject to change without notice. Because application and conditions vary, and are beyond our control, we are not responsible for results obtained in using this product, even when used as suggested. The user should conduct tests to determine the suitability of the product for the intended use under then existing conditions. Any liability we may have with respect to a product or its use (including liability for breach of warranty, strict liability in tort, negligence or otherwise) is limited exclusively to replacement of the product or refund of its price. Under no circumstances are we liable for incidental and consequential damages.
|
